INJORA Brass High Clearance Links Set for TRX4M Bronco Defender 1/18 RC Crawler Upgrade Parts, 38g/Set

Overview

INJORA part 4M-20 is a set of eight brass suspension links for the 1/18 Traxxas TRX4M crawler. It replaces the stock plastic links at the front and rear axles, four links per axle.

Each brass shaft carries an etched INJORA logo, and both ends of every link have a plastic rod end over a brass pivot ball. The full set weighs 38 g (1.34 oz). Sitting at axle height, that extra mass lowers the center of gravity, which helps a TRX4M resist rollovers on side slopes and keep traction while climbing.

Specifications

Part number

4M-20

Quantity

8 links

Link material

Brass

Rod ends

Plastic

Pivot balls

Brass

Set weight

38 g (1.34 oz)

Spacers included

1 mm

Fits

1/18 TRX4M Defender and 1/18 TRX4M Bronco

Individual link lengths are not published for this set. Compare the photos against your stock links if you need an exact match before ordering.

What is in the set

• Eight links: four straight and four with a bend for extra clearance
• Plastic rod ends with brass pivot balls fitted at both ends of every link
• 1 mm spacers for extending the upper links

INJORA's package list names the link set only. It does not say whether spare mounting screws are included, so keep your stock hardware until you have checked the box.

Spacers and setup

The 1 mm spacers extend the upper links. INJORA recommends two spacers at each upper link end. Lengthening the links changes the driveshaft angle and adds a little clearance under the chassis.

Fitment

INJORA lists two compatible models: the 1/18 TRX4M Defender and the 1/18 TRX4M Bronco. Both use the same eight-link layout.

The set does not fit the TRX4M High Trail K10 or F150 versions. Check your model before ordering.